Lorell LLR59605 Instructions D'assemblage page 2

Assembly Instructions
STEP 3
Only assemble one side leg using 12 pcs
screw "C".
STEP 5
h
IMPORTANT NOTE:
• Place all laminated parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
• Check to make sure that you have all parts and hardware.
• Remove all wrapping materials, including staples and packaging straps before you start to assemble.
• Do not tighten all screws/bolts until pieces are completely assembled.
• Keep all hardware parts out of children's reach.
• It is recommended for 2 persons to complete this assembly.
Suggest to keep the
distance of 5mm from metal
edge to panel edge.
h

STEP 4
Move /
60"T 72"T
inner bar to align outer bar edge.
60"T for table 60*24/60*30 & high table 60*24
72"T
for table 72*24/72*30 & high table 72*24
TWO PEOPLE ARE REQUIRED TO
ASSEMBLE AND MOVE THIS MODEL
 

If the other leg does'nt align the edge of
the top panel,usually need one man make
this leg at the correct position,another man
tighten 12 pcs screw "C".
black mark on the
Suggest to keep the
distance of 5mm from metal
edge to panel edge.
