Publicité
Kit Contents
Item Qty
Description
1
1
Expediter Assembly
Support Cap w/ O-ring
Threaded Grommet Compressor
Grommet
Support Base w/ O-ring
2
1
Junction Box Lid
3
1
Junction Box Base w/ O-ring
4
1
Thermostat w/ Terminal Blocks
(Refer to terminal specifications for maximum allowable wire size)
Thermostat Type
ZT-1-50
ZT-1-100
ZT-1-200
ZT-1-300
* The maximum pipe exposure temperature is limited to 250°C.
5
1
Junction Box Lid Cord
6
1
Nut
7
1
Banding Guide
8
1
Power Gland
9
1
Blind Plug
10
1
Conductor Wire Pin
11
1
Braid Wire Pin
12
1
Ground Sleeve
13
1
Banding
Tools Required
3 mm
8 mm
Certifications/Approvals
IP66
-45°C ≤ Ta ≤ +55°C
0539
II 2 G & D EEx ed II C T5 DEMKO 02ATEX132552X
Warnings
Due to the risk of electrical shock, arcing and fire caused by
product damage or improper usage, installation or maintenance,
a ground-fault protection device is required.
Installation must comply with Thermon requirements and be
installed in accordance with the regulations as per the norm EN
IEC 60079-14 for hazardous areas (where applicable), or any
other applicable national and local codes.
Install correct heating cable lengths indicated in the design. Any
deviations from these lengths will result in a change in outputs.
Control Range
-20°C to
+50°C
0°C to +100°C
0°C to +200°C
50°C to +300°C *
(per cable)
(per cable)
(per cable)
Terminator-LN-Tool
(order separately)
28 mm
29 mm
33 mm
1
4
6
7
PETK power termination components (per cable)
PETK-5:
for direct connection
PETK-6:
for cold lead connection
10
11
B-type banding
- order separately
B-4:
for pipes up to 4"
B-10: for pipes up to 10"
B-21: for pipes up to 21"
Component approvals and performance ratings are based on the
use of Thermon specified parts only.
De-energize all power sources before opening enclosure.
Keep ends of heating cable and kit components dry before and
during installation.
Minimum bending radius of heating cable is 5 times the cable
outer diameter.
2
3
5
8
- order separately
12
13
1
9
Publicité
