EN
10.- CLIP: LED excess signal indicator. It lights up red if there is an overload or excess power peaks.
Reduce the input signal level or the loudspeaker volume until the indicator goes off.
11.- DELAY: control to adjust the time interval between the echo effect repetitions.
12.- ECHO: control to adjust the number of repetitions of the echo effects.
13.- POWER: loudspeaker on/off switch.
14.- Input to connect the AC mains supply cable.
15.- AC SELECT: power supply voltage selector.
16.- SPEAKER OUTPUT: amplified output to connect to the passive loudspeaker, loudspeaker connector 8 Ω.
REMOTE CONTROL
1.-
: on/off button on the player.
2.- MODE: allows you to select the audio source.
3.- MUTE: turns the audio output on/off.
4.- EQ: allows you to select between the different existing equalisations.
5.- VOL +/-: player volume controls.
6.-
/ : in player mode, a short press skips to the previous/next song. In FM
mode, a short press skips to the previous/next station stored.
7.-
: in player mode, a short press plays/pauses audio playback. In FM mode,
a short press automatically memorises all detected frequencies with sufficient
signal quality.
8.- SCN: no function.
9.- RPT: in player mode, a short press selects the playback mode between: one
track, all tracks or random playback.
10.- 0-9: in player mode, it allows the selection of the audio track to be played; in
FM mode, it allows the selection of a station by its position in the memory.
- 4 -
1
2
MODE
3
4
MUTE
EQ
VOL+
6
5
CH -
CH+
7
VOL -
8
9
SCN
RPT
1
2
3
4
5
6
10
7
8
9
0