Nilfisk-cfm 3308 Manuel D'instructions page 28

3308 / 3508 / 3558
■ Versions for dusts harmful for the health: Classes L, M,
H suitable for vacuuming hazardous and/or carcinogenic
dusts (class H)
■ These operations can only be carried out by
qualified personnel who must wear adequate
clothing, in compliance with the laws in force.
■ Take care not to raise the dust during this
operation. Wear a P3 protective mask.
■ In case of dangerous and/or toxic dust, use
different kinds of safety bags or ABS containers.
■ Use a safety container if asbestos is to be
vacuumed. However, in this case the vacuum
cleaner must be equipped with ABS safety
container (Fig. 12) in order to dispose of the dust.
Alternatively, you may use the specific bag for
asbestos.
■ The container and/or bag must only be disposed
of by qualified personnel and in compliance with
the laws in force.
How to replace the ABS safety container:
■ Place the vacuum hose in a safe, dust-free place.
■ Release the container (1, Fig. 12).
■ Close the safety container with the supplied cover
and remove it from the dust container (1), fit an empty
container in its place.
■ Start the motor again to prevent dust from being blown
about.
■ Make sure that the gasket is in perfect condition and
correctly positioned.
■ Switch off the motor, fit an empty container in place and
fasten it in position.
Replacement of the safety bag for class H and asbestos
vacuum cleaners (Fig. 13)
■ Remove and put the vacuum hose in a safe and dust-
free place.
■ Close the inlet by using the relevant cap (1).
■ Release the dust container. Remove the bag making
sure that the union tubular element (3) is kept connected
GB
to the inlet.
■ Close the plastic bag hermetically.
■ Tighten the clamp (2) to close the inlet hermetically.
■ Remove the union element from the dust container inlet.
■
Insert a new safety bag making sure that the bag inlet is
sealed.
■ Wrap the plastic bag around the dust container external
wall.
■
Set the dust container into the vacuum cleaner again.
Before inserting the bag, remove the tubular element so
that it does not obstruct the input air.
C67
All manuals and user guides at all-guides.com
WARNING!
[ NOTE ]
Liquids vacuuming
Make sure that the vacuum cleaner is equipped with a liquid
level sensor and is suitable for vacuum liquids.
Do not vacuum flammable liquids.
If foam forms, turn off the vacuum cleaner immediately and
empty the container.
The filter element will be wet after liquids have been
vacuumed.
A wet filter element can quickly become clogged if the vacuum
cleaner is then used to vacuum dry substances.
For this reason, make sure that the filter element is dry or
replace it with another one before using the vacuum cleaner
for dry materials.
At the end of a cleaning session
■
Turn off the vacuum cleaner and remove the plug from
the socket.
■ Wind the connection cable around the cable carrier (Fig.
14).
■ Empty the container as described in the "Emptying the
container" paragraph.
Clean the vacuum cleaner as described in the
"Maintenance, cleaning and decontamination" paragraph.
■ Wash the container with clean water if aggressive
substances have been vacuumed.
■ Store the vacuum cleaner in a dry place, out of reach of
unauthorized people.
■ Shut the inlet with the appropriate plug when the vacuum
cleaner is transported or not being used (particularly in
the case of M, H and asbestos versions) (1, Fig. 14).
10
WARNING!
09/2014