Publicité
Les langues disponibles
Les langues disponibles
REINSTALL THE COVER
1. Return the LaundryPure 2.0 cover to its original position, fitting the
bottom in place and tipping upward.
2. Secure with two (2) screws (not shown) along the top edge.
3. Put the two (2) remaining screws along the bottom edge and tighten.
NOTE:
Remove the two black caps from the hose connections
before installing hoses.
HOSE INSTALLATION
• When connecting hoses to your LaundryPure 2.0 start by hand tightening the hose connector(s); using
CAUTION
• To ease hose installation and prevent cross threading, connect hose prior to mounting unit on wall
1. Turn the cold water off by shutting off the cold water faucet.
2. Remove the cold water hose from the cold water inlet on the back of
your washing machine. Leave hot water hose attached.
NOTE:
To help prevent water spray when disconnecting hoses, you can
relieve pressure in the water line by momentarily starting your
washing machine.
adjustable pliers, finish tightening hose connector(s); DO NOT remove or disconnect the hot water line
from your washing machine or water valve
Screws
Screws
7
Publicité
