Publicité
Les langues disponibles
Les langues disponibles
FOR WASHERS THAT REQUIRE HOT & COLD WATER INPUT
• Turn off both water valves (hot and cold) before disconnecting hoses; Failure to follow these instructions may
• When connecting hoses to your LaundryPure 2.0 hand start the hose connector(s); using adjustable pliers,
CAUTION
Some washing machine models require water pressure to both the Hot and Cold valves for proper operation. In some cases, if only the COLD
water side is connected, the water valve will not operate or the washing machine will not fill to the proper level. To solve this problem, the
installation of a "Y" adapter (available at most hardware stores) may be used. The use of the "Y" adapter allows water to flow equally through
both the HOT and COLD water valves. Optional stainless steel hose must be installed on the hot water connection. To Install, turn water off
at the valves and disconnect the existing HOT water hose (at the valve and washing machine). Connect the "Y" adapter to the outlet on your
LaundryPure 2.0, then connect both the optional stainless steel hose and Cold hose from your washer to the "Y" adapter (see diagram below).
Operate your washer on the WARM/WARM setting (your LaundryPure 2.0 will still be using just cold water).
NOTE:
Your hot source water valve will not have a hose connected to it. Make sure it is fully turned off. It is recommended you secure a cap
(available at most home improvement stores) to prevent leakage.
NOTE:
The "Y" adapter needs to be purchased locally. Use only a metal adapter. DO NOT use plastic.
Connect the "Y" adapter to the OUTLET on your
LaundryPure 2.0. Be sure to hold the fitting with
pliers while tightening the adapter.
Disconnect this stainless steel hose from
the OUTLET on your LaundryPure 2.0,
then connect it to the "Y" adapter.
12
result in water leakage and/or possible injury from hot water.
finish tightening hose connector(s)
Stainless steel hose supplied
Connect to COLD water inlet
on washing machine
plumbing COLD water valve
with LaundryPure 2.0.
Connect to HOT water inlet
on washing machine
Connect to household
"Y" adapter
Make sure the "Y" adapter
valve is in the on position.
NOTE: Use a metal "Y" adapter.
Do not use plastic
Disconnect the existing hose
from the HOT valve and washing
machine and remove. Replace
with optional stainless
steel hose.
Publicité
