Télécharger Imprimer la page

vollara LaundryPure 2.0 Mode D'emploi page 4

Système de lessive à eau froide

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION REQUIREMENTS
Never use an extension cord.
WARNING
• We strongly recommend that a licensed plumber installs the LaundryPure 2.0
• Water pressure MUST be checked and within stated specs before installation
• If water pressure is greater than 60 psi, Water Pressure Reducer MUST be used (sold separately)
• Incoming water pressure must be greater than 20 psi / 1.37 bar; if your household
CAUTION
• The washer's water valve may also not shut off completely; check the documentation supplied with your
• TO AVOID THE POSSIBILITY OF WATER DAMAGE, SHOULD A HOSE LEAK, ALWAYS HAVE FAUCETS
ELECTRICAL REQUIREMENTS
100 - 240 Volt 50/60 Hz 5 AMP (minimum) Fuse or Circuit Breaker. LaundryPure 2.0 is equipped with an AC to DC power supply.
WATER REQUIREMENTS
A dynamic water pressure greater than 20 psi / 1.37 bar and less than 60 psi / 4.13 bar is required to correctly operate your LaundryPure 2.0.
LOCATION CONSIDERATIONS
The LaundryPure 2.0 must never be installed in areas where water may freeze since the unit will always maintain some water in the unit, the
water valve, and hose areas. This can cause damage to internal components. It is also recommended to avoid installation in areas of high
humidity, as it can effect the operation of the unit.
5.19" (13.48 cm)
4
water pressure is greater than 60 psi / 4.13 bar, you must install an in-line pressure
reducer before installing LaundryPure 2.0; failure to follow these instructions may
result in water leakage, property damage, personal injury, and may void your warranty.
Water pressure of 20 psi / 1.37 bar to 60 psi / 4.13 bar is required to correctly
operate your LaundryPure 2.0; low water pressure may prevent your unit from
operating properly and/or cause a failure in your washing machine's water valve
washing machine for exact specifications; your washing machine and cold water faucet must be within
4 feet of the right side of the unit to use the inlet hose provided with your LaundryPure 2.0
ACCESSIBLE AND TURN OFF FAUCETS WHEN WASHER IS NOT IN USE; DO NOT USE WITH A
CARBON FILTER
17.3" (43.94 cm)
3.69" (9.37 cvm)
WATER
INLET
WATER
OUTLET

Publicité

loading

Produits Connexes pour vollara LaundryPure 2.0