EN
Safety
Symptom
The lights stay on
continuously.
The lights flash on and off.
Sensor will not operate at
night.
When setting the controls
in daylight the detection
distance becomes shorter.
216383_s1_s50-5059340231426-Goodhome-A5-IM-V05.indb 4
Possible Cause
The sensor may be picking up a
heat source, such as an air vent,
dryer vent, or bright painted,
heat-reflective surface.
The unit may be suffering from
false activation.
Ensure the unit is not positioned to
people using roads / footpaths
next to your property. Occasionally,
wind may activate the sensor.
(Sometimes passages between
buildings etc. can cause a "wind
tunnel" effect.)
Heat or light from the bulbs may be
turning the sensor on and off.
Heat is being reflected from other
objects and may be turning the
sensor on and off.
Sensor is sensing reflected light
from the light fixture.
The level of ambient light in the
area may be too bright to allow
operation.
Another light source is causing the
unit to think it is daylight.
Interference by sunlight.
Solution
Relocate the unit.
Cover the sensor lens completely
with a thick cloth. This will prevent
the sensor from ""seeing""
anything. If the unit now switches
off after the set time duration and
does not re-activate, this indicates
that the problem was caused by
false activation.
Slightly adjusting the direction /
angle of the sensor head.
Relocate the unit.
Relocate the unit, away from the
light source.
Relocate the unit.
1. Change position of light head
aim light away from the reflecting
surfaces.
2. Relocate the unit to a different
location where it no longer causes
reflected light.
Relocate the unit.
Turn off surrounding lights and/or
relocate the unit.
Re-set controls at night.
05-10-2021 13:22:03
04