Probuilder 26201 Manuel D'instructions page 25

17. Check regularly for damaged parts.
Always check for and replace defective
parts, including guards and the like
before using. Check that moving parts
are correctly set and can move freely.
Check for damage and missing parts that
can aff ect function. Damaged guards or
the like should be properly repaired or
replaced by a quali� ed service centre
unless otherwise indicated elsewhere in
the instruction manual. Have defective
switches replaced by a quali� ed service
centre. Do not use if on/off switch is
defective.
18. Warning! Use of non-recommended
parts can result in injury. Never point the
tool at other people. Beware of recoil or
ricocheting staples/tacks when working
with hard materials.
19. Always have tool repaired by an
authorised service centre. This electrical
tool complies with relevant safety
regulations. Repairs may only be
conducted by an authorised service
centre and using original spare parts.
Failure to do so can result in serious
injury.
Damaged cable must be replaced
by an authorised electrician with
corresponding cable (H05VV-F2 x 0.75
mm ).
2
Technical data
Voltage/frequency:
Speed:
Size of staples (Type 53):
Size of brads (Type 47):
Includes:
400 staples, 10 mm
100 brads, 14 mm
Sound pressure, L : 73.8 dB(A), K
pA
Sound level, L : Sound level, L Sound level, L
WA WA
Vibrations:
The table below shows how long you
may be exposed to vibration every day, if
the vibration load of 2.5 m/s
exceeded:
Vibration Max. exposure
2.5 m/s 8 hours
2
3.5 m/s 4 hours
2
5 m/s 2 hours
2
7 m/s 1 hour
2
10 m/s 30 minutes
2
220-240 V ~ 50 Hz
20 rounds/min.
6-14 mm
(0.75×11.4 mm)
15 mm
(0.9×1.25 mm)
: 3 dB(A)
pA
84.8 dB(A), K : 3 dB(A)
WA
4.678 m/s
K: 1.5 m/s
is not to be
2
25
GB
2
2