Orbegozo CV 4000 A Manuel D'instructions page 16

CV 4000
 There is tip over switch on the base. When the heater
tips over,
automatically.
 WARNING: do not use the product after a short
circuit
ASSEMBLY OF THE HEATER
Fitting the feet: carefully turn the unit upside down. Use 4 screws for feet to fix the 2 feet
onto the heater. Take care to ensure that they are located correctly in the bottom ends of
the heater side mouldings.
WALL MOUNTING (optional)
 Screws are provided to enable the unit to be mounted onto the wall if required.
 Important: when drilling into walls always check that there are no hidden wires of pipes etc. Make
sure that the screws and wall plugs supplied are suitable for supporting the unit. Consult a
qualified person if you are not sure.
 Warning: Position the heater carefully. It must be not in front of or below a power socket. It must
not be below a shelf, curtains or any other obstructions. The heater has to be installed at least
0.4m above the floor.
 OPERATION OF THE HEATER
NOTE: It is normal when the heaters are turned on for the first time or when they are turned
on after having not been used for a long period of time the heaters may emit some smell
and fumes. This will disappear when the heater has been on a short while.
Choose a suitable location for the heater, taking into account the safety instructions above.

Insert the plug of the heater into a suitable socket.

Turn THERMOSTAT KNOB fully in a clockwise direction to the maximum setting.

the electricity will be turned off
16