MasterCool COMMANDER 1000 Manuel D'instructions page 16

All manuals and user guides at all-guides.com
COMMANDER MACHINE BASIC OPERATION
Once the initial setup of the machine has been completed the machine is ready for operation.
The AUTOMATIC/MANUAL SCREEN will appear on the COMMANDER2000 (-E)/COMMANDER3000 (-E). The
manual screen will appear on the COMMANDER1000 (-E).
Choose the reclamation procedure desired.
AUTOMATIC (COMMANDER2000 (-E)/COMMANDER3000 (-E) ONLY): Recover, vacuum, vacuum
•
leak test, oil injection (COMMANDER2000 (-E), COMMANDER3000-E only) and refrigerant charge in
continuous process.
MANUAL: Recover, vacuum, oil injection (COMMANDER200 (-E) only) or refrigerant charge can be
•
done individually.
NOTE: The top of the screen will display language, pressure, temperature, units' of measure for refrigerant, oil
charge, time and date. To change these settings please refer to the main menu instructions at the beginning of
this manual.
To use the COMMANDER2000 (-E)/COMMANDER3000 (-E) in AUTOMATIC MODE please continue below. If
manual mode is preferred (COMMANDER1000 (-E)/COMMANDER2000 (-E)/COMMANDER3000 (-E)) please skip
to the manual section of these instructions.
COMMANDER3000 (-E) MACHINES (ONLY)
Once an automatic or manual procedure is selected, the next screen shown allows for the selection of a
standard or hybrid vehicle.
NOTE: Per SAE J2788, automatic oil injection for hybrid vehicles is prohibited. To inject oil into a hybrid
vehicle, use a manual hermetically sealed oil injector. (Follow vehicle manufacture recommendations)
16 www.mastercool.com