Hilti SID 2-A Mode D'emploi Original page 26

All manuals and user guides at all-guides.com
WARNING
Electrical hazards! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals
and the contacts in the impact screwdriver are free from foreign objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check
that the battery is securely seated in the power tool.
▶ Fit the battery and make sure that it is heard to engage.
5.2 Switching on
▶ Press the control switch.
◁ Speed of rotation is regulated by the distance the control switch is
pressed in.
5.3 Switching off
▶ Release the control switch.
5.4 Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the
middle position (safety lock).
▶ Set the forward/reverse switch to the desired direction of rotation.
5.5 Fitting an accessory tool
1. Set the forward/reverse switch to the middle position or remove the
battery from the tool.
2. Pull the chuck ring forward and hold it in this position.
3. Push the accessory tool into the chuck as far as it will go (until it engages).
5.6 Removing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when using the power tool and when changing
accessory tools.
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the chuck ring forward and hold it in this position.
20 English
Printed: 15.03.2019 | Doc-Nr: PUB / 5206085 / 000 / 02
2
4
5
2081236
*2081236*