Motorola Solutions IMPRES 2 Serie Mode D'emploi page 3

English
CHARGER: NNTN8845A
IMPORTANT SAFETY INSTRUCTIONS
This document contains important safety and operating instructions. Please read
these instructions carefully and save them for future reference.
Before using the battery charger, read all the instructions and cautionary markings on (1) the
charger, (2) the battery, and (3) the radio using the battery.
1. To reduce risk of damage to the power supply electric plugs and cords, pull
the plug rather than the cord when disconnecting from the AC outlet or the
! !
charger.
2. An extension cord should not be used unless absolutely necessary. Use of
W A R N I N G
an improper extension cord could result in risk of fire and electric shock. If an extension
cord must be used, make sure that the cord size is 18 AWG for lengths of up to 6.5 feet
(2.0 m), and 16 AWG for lengths up to 9.8 feet (3.0 m).
3. To reduce risk of fire, electric shock, or injury, do not operate the charger if it has been
broken or damaged in any way. Take it to a qualified Motorola Solutions service
representative.
4. Do not disassemble the charger. It is not repairable and replacement parts are not
available. Disassembly of the charger may result in risk of electric shock or fire.
5. To reduce risk of electric shock, unplug the charger power supply from the AC outlet
before attempting any cleaning.
6. To reduce risk of injury, charge only the rechargeable Motorola Solutions authorized
batteries listed in Table 1. Other batteries may explode, causing personal injury and
damage.
7. Use of accessories not recommended by Motorola Solutions may result in risk of fire,
electric shock, or injury.
OPERATIONAL SAFETY GUIDELINES
• This equipment is not suitable for outdoor use. Use only in dry locations and conditions.
• Recommended charger room temperature is 22 °C to 25 °C (71 °F to 77 °F). Room
temperature must not exceed 35 °C (95 °F).
• The radio can be turned ON only when it is transmitting data wirelessly, such as using
Wi-Fi. Otherwise, turn OFF the radio.
• Connect the charger only to an appropriate power supply listed in Table 2.
• The equipment shall be connected to a nearby and easily accessible socket outlet.
• Make sure the power supply cord to the charger is located where it will not be stepped
on, tripped over, or subjected to water, damage, or stress.
• Connect the power supply only to an appropriately fused and wired AC outlet with the
correct voltage, as specified on the product.
• Disconnect from line voltage by removing the power supply from the AC outlet.
1