Ribiland PRS500 Manuel D'instructions Et D'utilisation page 16

GB
Before making any adjustment, change of accessory, ensure that switch is on the «
OFF » position, or remove battery pack from tool.
FIGURE 2
[1] Shaft Lock Button
[2] Collet Nut
[3] Collet
[4] Wrench
[5] To loosen
[6] To tighten
To change a grinding stone:
1. Press shaft lock button [Fig.2 (1)].
2. Unscrew collet nut (by hand or with wrench) [Fig.2 (2)].
3. Insert a grinding stone in collet (collet capacity 2.4mm – 3.2mm).
4. Press shaft lock button [Fig.2 (1)].
5. Screw collet nut (by hand or with wrench) [Fig.2 (2)].
To change a collet:
1. Press shaft lock button [Fig.2 (1)].
2. Unscrew collet nut (by hand or with wrench) [Fig.2 (2)].
3. Remove collet and replace with new collet.
4. Insert a grinding stone.
5. Press shaft lock button [Fig.2 (1)].
6. Screw collet nut (by hand or with wrench) [Fig.2 (2)].
Note: Keep shaft lock engaged to screw and unscrew the collet nut.
V. OPERATION
Note:
- This tool is for household use and indoor use only.
- Insert a grinding stone in the collet adapted to the work you wish to carry out.
- Do not put pressure on the shaft. Apply light force and guide tool.
- Do not hold tool close to face and body.
- Small parts may fly apart as they come out with speed, wear appropriate protective
equipment.
Fig. 2
14
FIGURE 3
[1] Collet Nut
[2] Collet max 3,2mm
[3] Collet min 2,4mm
Fig. 3