Télécharger Imprimer la page

Pfister Marielle 46 Serie Instructions D'installation page 2

Publicité

Les langues disponibles

Les langues disponibles

Thank you for purchasing this Price Pfister product. All
Price Pfister products are carefully engineered, and factory
tested to provide long trouble-free use under normal
conditions. This product is easy to install using basic tools
and our easy to follow illustrated instructions. If you have
any questions regarding this product, call 1-800-Pfaucet
(1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• Plumber's putty
• Slotted screwdriver
• Adjustable wrench
• Flashlight
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
FAUCET INSTALLATION
Your faucet can be installed with or without the deck plate:
For installation using the deck plate:
For installation without using the deck plate:
• Pliers
• Cloth
Go To Step 4
Go To Step 6
ENGLISH
INSTALLATION USING DECK PLATE
4
BOTTOM GROOVE
4 DECK PLATE INSTALLATION
(For installation without the deck plate, go to step 6.)
Ensure that the Plastic Putty Plate (4A) is pressed on the Deck Plate (4B). Place a bead
of plumber's putty in the groove along the edge of the Putty Plate (4A). Install the Deck
Plate (4B) over the three holes in your sink.
5
5G
5 SPOUT INSTALLATION
Insert Lift Rod (5A) into hole at top of Spout Head (5B). Insert Spout Shank (5C) through
the center hole of Deck Plate (5D). From underneath sink, place Thrust Washer (5E)
onto Spout Shank (5C) and tighten with Mounting Nut (5F). Before final tightening, be
sure Spout (5G) is centered and facing forward.
Caution: Do not over tighten!
2
4A
5B
5C
5D
5E
5F
STOP
Go To Step 8
4B
5A

Publicité

loading