Publicité
Les langues disponibles
Les langues disponibles
TOOLS NEEDED FOR ASSEMBLY
1 - Box Cutter or Knife
2 - 1/2" Wrenches
1 - Pair Wire Pliers
1 - Hammer
1 - 1/2" Socket and Socket Wrench
1 - 1/4" Socket and Socket Wrench
1 - 1" thick x 1' square piece of wood
REMOVE GENERATOR FROM CARTON
•
Open carton from top.
•
Cut carton along dotted lines.
•
Remove generator through opening in carton.
•
Remove parts box containing wheel kit parts.
•
Cut wire tie securing handle assembly to top
frame.
•
Cut wire ties securing handle assembly to side
frame. This handle assembly stores the axle
during shipping. Remove the base end cap and
slide the axle from handle assembly. Replace
base end cap with washer.
•
Remove all packaging material from handle
assemblies and oil filter on engine.
•
Place handle assemblies aside to be used when
assembling the wheel kit.
•
Using a 1/2 inch socket remove shipping block
from under the generator head. Unscrew the bolt
and remove the wood block. NOTE: It is very
important that this is removed before starting your
generator.
IMPORTANT: Before any attempt to start your genera-
tor be sure to check engine oil (See Adding Engine Oil
paragraph in the Operation section on page 15 of this
manual.)
MGP-670070
All manuals and user guides at all-guides.com
Read owner's manual. Do not attempt to operate equipment until you have read Owner's
Manual for Safety, Assembly, Operation, Maintenance, Storage Instructions.
Base
End
Cap
Axle is stored in
Parts Box
Handle Assembly
containing
secured to side
Wheel Kit
frame
parts
10 — ENG
Handle Assembly
secured to top frame
Make sure
packaging
material is
removed from oil
filter on engine
Publicité
