CAMPAGNOLA POWER MOTOR PRO Livret D'utilisation Et D'entretien page 25

way the engine unit parts (starting system, carburettor) do not overheat.
WARNING!
• As soon as the engine starts working, the tool produces harmful exhaust gas, which can be odourless and
invisible.
• Do not use the tool indoor or in scarcely airy rooms.
5.5 Extension pole and tool assembly
5.5.1 Extension pole assembly
Carry out the following operations:
a) Insert the joint (12) (picture F) into the shaft.
b) Insert the extension pole (13) (picture. G).
c) Tighten the screw (14) (picture G).
5.5.2 Harvesting head assembly
Carry out the following operations:
a) Insert the joint (12) (picture H) into the shaft.
b) Insert the harvesting head into the extension pole (13) (picture I).
c) Tighten the screws (14) (picture I).
5.6 Troubleshooting
WARNING!
All special maintenance operations shall be carried out only by well-trained personnel.
FAULTS
The engine does not start.
Overheating comes out of the gearbox.
The harvesting head does not move.
The harvesting head moves slowly
NOTE: If the indicated remedies do not solve the problems, take the unit to an Authorized Service Point.
WARNING!
It is forbidden to modify the accelerator adjustment set out by the Manufacturer.
The carburetor has been calibrated to use harvesting heads running at a speed which should not exceed 1250 rpm.
The non-respect of these warnings makes the tool warranty void.
Campagnola Srl – USE AND MAINTENANCE MANUAL – Traslation of the original Instructions
Ver.1.0 - Rev.: 02, Date: 11/09/2020
CAUSE
Missing fuel.
•
The pre-starting procedures have not
•
been carried out properly.
Missing lubrication.
•
Worn-out component.
•
The extension pole has not been in-
•
serted properly.
The carburetor is in break-in phase
•
REMEDY
Add fuel.
•
Check the engine manual.
•
Take the tool to an Authorized Service
•
P oint.
Check the extension pole and the trans-
•
mission joints for proper positioning.
The right break-in occurs after about
•
one working day
Pag.24