Publicité
Step 5: Arms with front bar assembly:
Put front bar feet bolt through the hole of small arm, then position the front bar. After
positioning, tighten the nut with wrench, as fgure below:
Step 6: Link the self-locking nut
Link the self-locking nut into screw which at the bottom of the screw in front bar feet
by a wrench, stop when the thread:leakage 1 ~ 2 laps.As shown in the figure below:
ATTENTION: BEFORE BLOCKING THE NUT.ENSURE THAT THE ARMS ARE
PROPERLY ALIGNED.
7
05
EN
Publicité
