Publicité
Step 11: Right roller support assembly:
Insert the shaft of roller into roll tube plug，meanwhile insert the torsion bar into the
right roller supports with hitting. Then tighten the right hexagon bolt by 5mm
Hexagon wrench.As shown in the figure below:
Step 12: Assemble to make a whole awning
Make the valance through groove of front bar, pay attention to the direction and
make sure the left and right sides on average, then hitting the cover of front bar into
end of front bar. As shown in the figure below:
lf the part of front bar is a little deformed, please adjust it with tools by yourself.
10
11
EN
Publicité
