Motorisation+ SAFEDUO Instructions D'installation Et D'utilisation page 8

4 - INSTALLING THE PRODUCT
ASSEMBLY DESCRIPTION
• Prepare for the passing of the cables
• Open the cover of the photocells with the help of a screwdriver (Fig. 1)
• Secure the base to the wall using the screws provided (Fig. 2)
• Proceed with required wiring following Fig.3 (electric diagram for photocell connection or following
Fig.4 (electric diagram for couple of synchronized photocell connection)
• Check the alignment of transmitter and receiver making sure that led "L" of receiver remains
continuosly on (Fig. 5)
• Select the desired typology for OUT contact (J3)
• Mount the cover with the infrared screen
• Verify J3: Contact normally closed NC (by factory default) - Contact normally open NO
SYNCHRONIZATION:
allows two pairs of photocells to operate without reciprocal interference. To activate this function, the
photocells must be powered by VAC and the jumper shown in figure 4 must be moved towards S.
"SNOW" FUNCTION:
the photocell automatically adapts response times in the event of false darkening caused by
atmospheric phenomena such as snow or heavy rain.
ATTENTION !
LOW RANGE:
to avoid interference between the photocells and consequent insensitivity to obstacles, due to the
excessive proximity between them, remove the jumper to lower the range from 25 m. to 8 m. (Fig.3)
5 - TESTING AND COMMISSIONING
The testing of the system must be performed by qualified technicians who must perform the tests
required by relevant legislation related to risks, ensuring compliance with the provisions of the regu-
lations, in particular the EN12445 standard, which specifies the testing methods for the automation of
doors and gates. Following the successful testing of every (and not just some) device in the system,
you can proceed with the commissioning, following the instructions provided with the main product
6 - MORE INFORMATION
OPTIONAL DIAPHRAGM:
In case of necessity, to reduce the cone of the receiver insert the provided optional diaphragm into it (Fig. 6)
DECLARATION OF CONFORMITY
LABEL HABITAT declares that the product is compliant with the relevant directives in force at the
time of production.