2. Preparations (continued)
Connection to computer
Connect the KY-F75's IEEE1394 connector to the IEEE1394 host adapter card with the IEEE1394
cable.
KY-F75 rear panel
LENS
REMOTE
DC IN
POWER
SEE INSTRUCTION MANUAL
Attaching the clamp filter
The power to the KY-F75 can be supplied through the IEEE1394 connector of the
computer. However, the following precautions must be adhered to.
Precautions on power supply
• When supplying the KY-F75 with power though the IEEE1394 cable, make sure that the capacity on
the supplying side is sufficient to meet the consumption by the KY-F75 (approximately 600 mA in the
case of DC 12 V).
When supplying the KY-F75 with power from the computer, make sure that sufficient power is sup-
plied to the power supply connector of the IEEE1394 host adapter card.
For details, see the instructions for the IEEE1394 host adapter card.
• When the motorized lens is used, make sure to supply the power from the camera's [DC IN] connector.
E14
All manuals and user guides at all-guides.com
IEEE1394
IEEE1394 cable
To [IEEE1394]
connector
IEEE1394
Host
Adapter
● To reduce the emission of unwanted radio waves,
make sure to attach the provided clamp filter to
the IEEE1394 cable as shown in the figure on the
left.
● Attach the clamp filter as close as possible to the
KY-F75.
PC