Publicité
Les langues disponibles
Les langues disponibles
Changing Oven Light
(some models)
Be sure the oven is
unplugged and all parts are COOL before
replacing the oven light bulb.
Adjusting Oven
Temperature
All manuals and user guides at all-guides.com
The oven light automatically turns on when the door is opened. To turn the oven
light on and off when the door is closed, use the LIGHT pad located in the control
panel.
Changing the Oven Light
The oven light bulb is located at the rear of the oven. To replace, follow these
instructions:
1. Turn electrical power off at the main source or unplug the oven. BE SURE ALL
PARTS ARE COOL BEFORE REMOVING BULB.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Press wire holder to one side to release the glass shield.
4. Replace bulb with a new 40 watt appliance bulb.
5. Replace glass shield in socket and snap wire holder into place.
6. Turn power back on again at the main source (or plug the oven back in).
7. The clock (if equipped) will then need to be reset. Follow instructions under
Setting the Clock and Minute Timer.
The temperature in the oven has been set at the factory. When first using the oven,
be sure to follow recipe times and temperatures. If you think the oven is too hot or
too cool, the temperature can be adjusted. Before adjusting the oven temperature,
test a recipe by using a temperature set higher or lower than the recommended
temperature. The baking results should help you to decide how much of an
adjustment is needed.
To Adjust the Oven Temperature:
1. Push the BAKE pad.
2. Set the temperature to 550°F/288°C by pushing the UP or DOWN ARROW
pad.
3. Within 2 seconds, push and hold the BAKE pad for approximately 5 seconds
until the special 2 digit display appears. Release the BAKE pad.
The display now indicates the difference in degrees between the original factory
temperature setting and the current temperature setting. If the oven control has
the original factory calibration, the display will read "00."
4. The temperature can now be adjusted up or down 35°F/17°C, in 5°F/3°C
increments, by pushing the UP or DOWN ARROW pad. Adjust until the
desired amount of offset appears in the display. A minus sign (-) will appear
before the number to indicate the oven will be cooler by the displayed amount
of degrees.
5. When you have made the desired adjustment, push the CANCEL pad to go
back to the time of day display.
1 8
Publicité
