Publicité
INSTALLATION & USE
NOTE:
Using the TelosXL
replace a bolt in the top mounting plate. Use the provided template below to insure proper placement
IF
your carriers contain this hole already, just install the longer bolt as pictured below and
1). Position the TelosXL
rear of the top mounting plate and aligns with the slot in the
SeaWing
. See figure 1.
TM
Insert and pull-down to engage the attachment clip and seat the bolt
into the hole. The bolt prevents the Telos
loading procedures.
2). With the top plate secured, loosen the knobs on the assembly
connector on the backside and slide the extender downwards
until the black locking collar is clear of the bottom. Fully tighten the
knobs. See figure 2
3). Loosen the black locking collar and slide the extension out to the
desired length to reach the ground. Twist to secure the collar in place
and flip the foot pedal out to complete installation.
See figures below.
NOTE: When extending the TelosXL
the unit as close to the vehicle as possible, or as vertical as possible
without making contact. This will insure easier function and use.
Twist collar to loosen
and secure extension.
with older SeaWing
TM
of the required hole if your carriers do not have one already.
skip to the next steps.
CUT ME OUT
so the attachment clip is located on the
TM
TM
to the ground we want to keep
TM
Foot pedal
This concludes the Saddle Style installation.
(Installing the TelosXL
TM
carriers requires the user to drill a small hole and
TM
from rotating during the
to the MPG107 SeaWing
1
2
3
)
TM
Publicité
