Publicité
INSTALLATION & USE
First, confirm that the kayak carriers are secure and located directly
inside the cross rail towers. You'll dress the straps as described in
your kayak carriers instructions.
NOTE: NEVER MOUNT THE CARRIERS OUTSIDE OF THE
CROSS RAIL TOWERS. THIS APPLIES TO BOTH FACTORY
AND AFTER-MARKET CROSS RAILS.
1). Position the TelosXL
rear of the top mounting plate and aligns with the slot in the
carriers loading ramp. See figure 1.
Insert and pull-down to engage the attachment clip.
2). With the top plate secured, loosen the knobs on the assembly
connector on the backside and slide the extender downwards
until the black locking collar is clear of the bottom. Fully tighten the
knobs. See figure 2
3). Loosen the black locking collar and slide the extension out to the desired length to reach the
ground. Twist to secure the collar in place and flip the foot pedal out to complete installation.
See figures below.
NOTE: When extending the TelosXL
possible, or as vertical as possible without making contact. This will insure easier function and use.
Twist collar to loosen
and secure extension.
(Installing the TelosXL
so the attachment clip is located on the
TM
to the ground we want to keep the unit as close to the vehicle as
TM
Foot pedal
This concludes the J-Style installation.
to the Loading Ramp of the MPG106, MPG114, MPG118)
TM
1
2
Publicité
