Publicité
Les langues disponibles
Les langues disponibles
7.
Attach the valve-holder to the shorter tubing and
attach the spray hose to the valve-holder.
NOTE:
The provided small black rubber washer needs to be installed here.
DO NOT use putty or other sealant agents at this joint.
8.
Attach approved connector hoses to the two longer copper tubes and connect to
water supply valves.
WARNING!
Do not allow the supply tubes to twist or bend sharply.
NOTE:
It is recommended to use approved stainless steel braided supplies.
9.
Flush out debris from water lines and faucet.
1.
Pull spray hose out of the faucet spout and point the open end towards the
sink drain.
2.
Open faucet handle - cold side first - by turning handle to the right and mov-
ing it upward
3.
Let the faucet run on cold for 15 to 30 seconds.
4.
Open faucet handle - hot side second - by turning handle to the left and mov-
ing it upward.
5.
Let the faucet run on cold for 15 to 30 seconds.
6.
Turn faucet off.
7.
Test for leaks under the cabinet.
All manuals and user guides at all-guides.com
4/8
Publicité
