Oreck 1600 Serie Guide D'utilisation page 13

All manuals and user guides at all-guides.com
Replacing the Micro Filter
The micro filter is extra protection against dust and dirt
getting into the vacuum motor. To keep your vacuum running
in top condition you will want to change the micro filter when
it gets dirty.
To replace the micro filter:
1. Follow steps 1-3 on page 12, Replacing the Disposable
Inner Bag.
4. To remove the Micro Filter, lift up on the recessed finger tab
and pull out.
5. Remove the Micro Filter from the Micro Filter Frame.
6. Replace by pressing a new Micro Filter onto the tab located
on the underside of the Micro Filter Frame.
7. Insert the Micro Filter Frame into the housing under the ribs
located at the back of the housings, and locate the rear tab
between the ribs.
8. Insert the inner bag back into place, and close the inner
bag door.
IMPORTANT: Never remove the white gasket surrounding the
inner bag opening. The vacuum will leak air and not
run properly.
4
TAB
5
7
13
4
TAB
6
HOLE
7
HOLE