EN
DIRECTIONS FOR USE AND MAINTENANCE
STORING THE PACKAGE BEFORE ASSEMBLING YOUR PRODUCT
•
Store the package in a dry and ventilated place, away from direct sunlight and protected from bad
weather.
•
The package and parts should be laid flat on the ground in order to avoid any deformation.
•
We recommend you to unpack the product components 48 hours before installing it and to store it in
a covered place, so that the wood can be adapted to the moisture content of the air.
SAFETY ADVICE
•
The wooden parts may cause splinters. Handle the wood carefully, using protective gloves.
•
Always follow the instructions and the assembly order carefully, according to this user manual.
•
Avoid direct contact with a heat source (candle, electric device, heater, etc.).
•
Check there are no nails, screws or staples exceeding the assembled pieces.
ASSEMBLY
•
This product must be assembled by an adult.
•
You must pre-drill the holes at a lesser diameter than that of the screws before inserting and tighte-
ning the screws.
•
Before starting, check that the base on which the product is to be built is perfectly flat and level.
•
With the assembly instructions, check that you have all the parts to assemble your product.
MAINTENANCE
•
Wood is a living material that never stops altering and may be slightly deformed (wood can be slight-
ly warped) or have imperfections such as splits, knots and resin pockets. It may also lose its shine,
darken...This is normal and does not affect the lifespan of your product. Wood pulp (not supplied)
can be an easy solution.
•
We recommend to treat the product twice a year, using a product for protecting exterior wood sur-
faces.
•
Regularly clean of leaves and other remains.
•
Likewise, avoid snow accumulation, it can cause an overload and cause damage or even the col-
lapse of the structure.
•
Monitor the possible development of mold and moss at the base or on the walls, especially on parts
ex posed to the North. If necessary, remove them.
9
24/11/2022