Urmet 1723/46 Instructions D'installation page 10

6
If products 1723/11-/12 or 1784/1-/2 or
1784/3-/4, 1723/48 and 1723/46 are installed
on the single row, the arrangement shown in
the following drawing must be respected.
TERMINALS
+~ Power positive (12Vac or 12Vdc)
-~ Power negative (12Vac or 12Vdc)
H Time input
A2 Relay 2 hall door release button
A1 Relay 1 hall door release button
S3 Normally open contact relay 1
S2 Normally closed contact relay 1
S1 Common contact relay 1
S6 Normally open contact relay 2
S5 Normally closed contact relay 2
S4 Common contact relay 2
GND Ground
PROGRAMMING
MASTER PASSWORD PROGRAMMING PROCEDURE
The master password is required to access device confi guration programming mode.
Power the device.
Press the programming switch next to the terminal board 3 times in 5 seconds.
The device generates 3 confi rmation beeps and the button
Enter the password code (from 3 to 8 digits).
Press to confi rm.
The device will beep 3 times to confi rm. The button
normal operation.
To modify the master password, if required, disconnect the device from the power supply for at
least fi ve seconds and repeat the procedure described above.
10
All manuals and user guides at all-guides.com
J3
7
turns from blue to red.
turns from red to blue and the device switches to
2
1
DS1723-008B