Télécharger Imprimer la page

Vimar Clima 01923 Manuel Pour L'installateur page 18

Masquer les pouces Voir aussi pour Clima 01923:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
• To finish the procedure, press button C on the programmable ther-
mostat . In the case of the 01924 four channel actuator-receiver,
repeat the procedure to configure the other channels .
4.CONFIGURATION
CHRONOTHERMOSTATS 01911.
• Replace the relay module in the timer-thermostat 01911 with the
radio-frequency transmitter module 01921 .1 .
• On the timer-thermostat, go to the SETTINGS menu and select
CONFIG . RF; the screen will show CONFIG . RF . Using the rotary
knob, select the desired channel (from 1 to 4) corresponding
to the relay you want to control (if using receiver 01923 always
select channel 1) . Press the
transmission phase commences .
• The transmission continues for 40 seconds, then the system stops
the procedure and goes back to the CONFIG RF menu item . The
transmission can be stopped manually by pressing the
tion button a second time .
• During the transmission, on the receiver 01923 or 01924 press
button P until the green LED blinks . Wait for channel programming
to be signalled by the red LED corresponding to this channel blin-
king .
All manuals and user guides at all-guides.com
OF
PROGRAMMABLE
selection button; the configuration
• To display the level of reception press button P until the green
LED goes out; the level is shown by the number of red LEDs that
light up:
- red LED 1: poor reception
- red LED 2: sufficient reception
- red LED 3: good reception
- red LED 4: optimum reception
Press button P until the green LED lights up again, to exit the
programming phase .
• If it has not yet ended automatically, stop the timer-thermostat
transmitting the configuration, press the
If using the 4-channel actuator 01924, repeat the procedure for
each of the channels you want to configure .
5. RESET PROCEDURE.
Press and hold down the button P for 5 seconds; this will clear all the
selec-
values stored in memory . The operation is signalled by the simultane-
ous blinking of all the red LEDs and the green LED .
}
green LED: off
selection button .
11 - ENGLISH

Publicité

loading

Ce manuel est également adapté pour:

Clima 01924