Motorola Solutions MTP6000 Serie Mode D'emploi page 7

All manuals and user guides at all-guides.com
DISPLAY MESSAGES AND LED INDICATIONS
Table 7: Messages and LED Indications for IMPRES 2™ or IMPRES Battery
Status
Charger Powers On
Battery Detected
Requesting IMPRES
Battery Calibration
(Calibration is disabled in
charger)
• Press OK to enable
Calibration
• Ignore for normal
charging
(message disappears
after one minute)
Battery Discharging
Rapid Charging
Charged to 90% or more
Charged to 95% or more
Fault
Charger Display
IMPRES 2
CHARGER
IMPRES 2
BATTERY
or
IMPRES
BATTERY
ENABLE BATTERY
CALIBRATION?
CAL DISCHARGE
xxxx0mAh yyy%
RAPID CHARGE
xxxx0mAh yyy%
TRICKLE CHARGE
xxxx0mAh yyy%
CHARGE COMPLETE
xxxx0mAh yyy%
NOT CHARGEABLE
REMOVE& REINSERT
LED Indication
Green for approximately one second.
Battery does not require Calibration:
Steady Red
Battery requires Calibration but
Calibration is disabled in charger:
Alternating Amber and Green for
four seconds.
Steady Red
Steady Amber
Steady Red
Flashing Green
Battery does not require Calibration:
Steady Green
Battery requires Calibration but
Calibration is disabled in charger:
Alternating Amber and Green for
four seconds then,
Battery may be nearing End of Service
(battery is usable):
Alternating Red and Green
Flashing Red
Steady Green.
5