Baninni UGO BNDT001 Mode D'emploi page 36

MANUAL
1.Speed up
6.Bird sound
6.Water sound
8.Mode switch
button
7.motion detection
Control panel function instruction ：
1) There are 8 types of swing speed( 8 indicator lamps) on speed adjust button. Press
"+" for speed up, "-"for speed down.（ as below picture shows ）
2) There are three types of time setting. Press the button once, light will be on for 8
minutes. Press it second time, the light will be on for 15 minutes. Press it third time,
the light will be on for 30 minutes. When setting time is reached, all functions will stop.
If time setting function is not used, all using function will start working until power is off.
3) Play/pause button. Press the button once to start playing music. Press it second time
to stop playing music. The button has the same function under U-disk and APP mode.
4) Volume/next song button. After pressing music play button, press this button to play
next song (the swing has 12 melodies). Press "volume/next song" button for a while to
adjust volume. After concerning volume, release your hand. Use the same way to adjust
volume under U-disk and APP mode.
5) Bird and water sound button. Press "bird sound" button for bird sound, press it again
to stop. Press "water sound" button for water sound, press it again to stop. (Notice that
when playing bird and water sound, pressing the "play/pause" button can also stop the
sound.
6) Motion detection. When pressing "this" button, indicator light will be on.
Press any button to quit this mode. If voice control detection sensor receives
continual two or more sound, the machine will start working. It will swing in
lowest speed and play music of the swing in middle volume
1.Speed indicator lamp
1.Speed down
4.Music play and pause
5.Volume/music selection
Timer button
2.Timer indicator lamp
3.USB connector