Fox MINI MICRON Manuel D'instructions page 2

ENGLISH
• WEATHERPROOF SEALED CASE
• DIGITAL CIRCUITRY
• D - TEC™ SENSING SYSTEM (DTSS)
• LOW BATTERY DRAIN
•5MM RED LED'S
'
PIEZO SPEAKER
1. Turn off 2. Using a cross head
unit prior to screwdriver unscrew
fitting or the two battery cover
replacing screws.
batteries.
3. Pull the tab upwards
from the bottom of
the battery cover.
DO NOT over tighten the battery compartment screws,
excessive force will damage the screw threads.
All manuals and user guides at all-guides.com
4. Take care removing the bat-
teries. Insert new batteries and
ensure correct polarity.
5. For best weatherproofing,
ensure battery cover has a good
seal by firmly pushing lip into
the top edge of the case and
pivoting it into position.
6. Re-fit cover and screws.
• Push down the toggle switch and release to activate the unit.
• Push up and release the toggle switch in the top position to deactivate the unit.
Please ensure the unit is switched off before attempting to fit the Mini Micron
hardcase.
• Do not use excessive force when fitting the hardcase as this may result in damage
to the alarm.
Volume can be cycled incrementally
by presseing the volume button and
then releasing.
Tone can be cycled incrementally
by pressing the tone button and
the releasing.
2
Sensitivity can be cycled
incrementally by presseing the
sensitivity button and then
releasing.
The LED intensity can be toggled
between three different intensities.
Simply hold down the volume and
press the tone button.
Each time the tone button is
pressed the LED intensity will
change.
When the Mini Micron batteries are too low the LED's will automatically begin to flash
red every 2 seconds. They will remain flashing red until new batteries are inserted
into the alarm. Once new batteries have been placed into the Mini Micron the LED's
will cease flashing and return to normal.
No audible low battery warning is given by the Mini Micron.
Power Out Socket allows Fox Illuminated Bite Indicators to be powered directly
from the Micron. The Illuminated Bite Indicator will then light up when the Micron is
activated and latch for approximately 20 seconds.