You can also install the motion sensor in your garage, dining room, or basement.
Height and Tilt Angle
The motion sensor should be mounted 2m / 6 ⁴ / ₇ ft to 2.5m / 8⅕ ft above the floor
with a tilt angle of preferably 20º downwards. If you have a large pet weighing more
than 50 lb, change to a 10º downwards tilt.
With Pets
10°
05 English
All manuals and user guides at all-guides.com
No Pets
20°
To better detect the area where people may break in, rotate the motion sensor
horizontally up to 30º.
Sensitivity
The sensitivity can be adjusted based on the room size. The default setting is medium
sensitivity.
Mount the Motion Sensor
1. There are two methods of mounting the motion sensor at the selected location:
•
Use the 3M adhesive strip:
① Snap the adjustable wall mount onto the motion sensor base.
② Stick the adhesive strip on the back of the sensor, remove the film, and stick
the motion sensor on the wall.
③ Rotate the motion sensor to adjust the detection coverage.
•
Use the provided screws:
① Place the mount against the wall and use a pencil to mark the desired
location for mounting.
② Drill holes at each marking. No need to drill a pilot hole in the wooden walls.
English 06