MSI Micro-ATX B85M-P33 V3 Serie Mode D'emploi page 20

JCI1: Chassis Intrusion Connector
This connector connects to the chassis intrusion switch cable. If the computer case
is opened, the chassis intrusion mechanism will be activated. The system will record
this intrusion and a warning message will flash on screen. To clear the warning, you
must enter the BIOS utility and clear the record.
CPUFAN1, SYSFAN1: Fan Power Connectors
The fan power connectors support system cooling fans with +12V. If the motherboard
has a System Hardware Monitor chipset on-board, you must use a specially designed
fan with a speed sensor to take advantage of the CPU fan control. Remember to
connect all system fans. Some system fans may not connect to the motherboard and
will instead connect to the power supply directly. A system fan can be plugged into
any available system fan connector.
Important
• Please refer to your processor's official website or consult your vendor to find
recommended CPU heatsink.
• These connectors support Smart Fan Control with liner mode. The Command
Center utility can be installed to automatically control the fan speeds according to
the CPU's and system's temperature.
• If there are not enough ports on the motherboard to connect all system fans,
adapters are available to connect a fan directly to a power supply.
• Before first boot up, ensure that there are no cables impeding any fan blades.
All manuals and user guides at all-guides.com
CPUFAN1
20
SYSFAN1