Costway NP10851WH Manuel Du Propriétaire page 10

Assembly Instructions Trouble Shooting
Obstruction of
gas flow
Burner will
Spider webs or
insect nest in
not light
the venturi
with match
Burner ports
clogged or
Hose from gas
The fire pit
fire pit is
emits a lot
pinched
Flame is being
when in obstructed at
burner ports or
use
mixing chamber
of the burn
or obstructed
Out of Gas
Sudden drop
in gas flow,
Excess flow
or a reduced
safety device
flame height
may have been
activated
18
Clean the venturi.
Reference Problem: Irregular
flame pattern on the following
page. Clean the burner ports as
described there.
pinched between the fire pit
and the source of the gas.
on the burner are free of any
flame can flow naturally. Clear
out the mixing chamber located
before the Venturi.
seconds and light outdoor fire
pit.If flames are still too low,
reset the excessive flow safety
device by turning off the control
Disconnect regulator. Turn
Reconnect regulator and perform
outdoor fire pit.
Trouble Shooting Assembly Instructions
Burner ports
Irregular
are clogged or
flame
pattern,
flame does
not run the
full length of
the burner
High or gusting
winds
Flame blows Low on LP gas
out
Excess flow
valve tripped
Ice has built up
Flame seems
on the outside
to lose heat
of the LP gas
when burning
in cold
weather -
process is too
temperature low
Problem: Problem: The burner only lights up for a few
seconds, then it automatically turns off.
Clean burner ports.Do this by
inserting a paperclip into each
of the burner ports to ensure
they are not clogged.
not on, and has had sufficient
time to cool before touching it.
Increase flame to HIGH setting.
Refer to Problem: Sudden drop
in gas flow.
Replace with a spare LP gas
burning. Store the spare LP gas
ventilated area, away from
children.
19