IQOS ILUMA Manuel D'instructions page 12

IQOS ILUMA™ and IQOS ILUMA PRIME™ Holder (Model C1402):
Step 1: The device should be fully discharged before disassembling it.
Step 2: Open the Ring.
Step 3: Open the retainer cap, slide out the assembly out from housing.
Step 4: De-solder the battery tab and lifted it up.
Step 5: Remove battery and dispose of according to local regulations.
Confirmation of Compliance
Hereby, Philip Morris Products S.A. declares that IQOS ILUMA™ and
IQOS ILUMA PRIME™ are in compliance with the essential requirements and
other relevant provisions of Directive 2014/53/EU. The official Declaration of
Conformity may be found at: www.pmi.com/declarationofconformity.
IQOS ILUMA™ and IQOS ILUMA PRIME™ operate within 2.402 – 2.480GHz
frequency band with a maximum RF output power below 10.0 dBm.
This device complies with the RF exposure limits and has been evaluated in
compliance with portable exposure condition according to the EN 62311:2008.
Designed and manufactured under the authority of Philip Morris Products S.A.,
Quai Jeanrenaud 3, 2000 Neuchâtel, Switzerland.
Germany:
Importer and authorized representative: Philip Morris GmbH,
Am Haag 14, 82166 Gräfelfing, Germany
WEEE-REG.-Nr. DE: 45546419
Austria:
Distributed by: Philip Morris Austria GmbH,
Vorgartenstr. 206 B-C, 1020 Vienna, Austria
Switzerland:
Imported by Philip Morris Products S.A.,
Quai Jeanrenaud 3, 2000 Neuchâtel (Switzerland)
The Bluetooth® word mark and logos are registered trademarks owned by the
Bluetooth SIG, Inc. and any use of such marks by Philip Morris Products S.A.
and its affiliates is under license. Other trademarks and trade names are those
of their respective owners.
Further information regarding the firmware license for IQOS ILUMA™ and
IQOS ILUMA PRIME™ is available at www.iqos.com.
Not all devices listed in these Safety Warnings and Instructions are included
in this mobility kit.
© 2021 Copyright Philip Morris Products S.A.