Télécharger Imprimer la page

IQOS ILUMA Manuel D'instructions page 11

Masquer les pouces Voir aussi pour ILUMA:

Publicité

Les langues disponibles

Les langues disponibles

For Germany:
Owners of waste equipment and batteries purchased from the Philip Morris
GmbH may return them free of charge to any IQOS store in Germany or return
them by mail to Philip Morris GmbH; in the latter case, Philip Morris GmbH will
provide you with a return label free of charge - please check www.iqos.com for
details of an intended return.
For Austria:
Please check www.iqos.at for information about where you can drop off your
waste equipment and batteries for recycling. Owners of waste equipment and
batteries purchased from the Philip Morris Austria GmbH may also return them
off free of charge to the IQOS Boutique in Austria.
For Switzerland:
Owners of waste equipment and batteries purchased from Philip Morris
Switzerland Sàrl may return them free of charge to any IQOS Boutique in
Switzerland.
For Italy:
Moreover, the waste equipment can be returned free of charge to the point of
sale in case of supply of a new electrical and electronic equipment. The waste
equipment can be returned in any case free of charge to points of sale where
the sales area for electrical and electronic equipment ("EEE") is larger than 400
square meters. The local importer of the product will provide for the financing
of the treatment and recycling of waste equipment returned through these
designated collection points in accordance with local requirements.
E.E.E. Register n: IT16060000009351
BATTERY REMOVAL INSTRUCTIONS (FOR DISPOSAL AND
RECYCLING)
Batteries must not be removed by the consumer. At end of product life,
only an authorized recycler may safely remove batteries by following the
steps below.
IQOS ILUMA PRIME™ Pocket Charger (Model C1502):
Step 1: The device should be fully discharged before disassembling it.
Step 2: Remove/peel off the rubber pad from the Pocket Charger Wrap Cover.
Step 3: Remove the 2 screws.
Step 4: Remove Wrap Cover by sliding and wiggling vertically slowly away from
Metal Housing, then remove the 2 screws of the frame.
Step 5: Detach all Flexible Printed Circuits and connector to remove the
charger Printed Circuit Board.
Step 6: Remove battery by tilting it up and dispose of according to local
regulations.
IQOS ILUMA™ Pocket Charger (Model M0001):
Step 1: The device should be fully discharged before disassembling it.
Step 2: Remove Door Cover with fingers.
Step 3: Open door and unscrew bottom and top screw.
Step 4: Remove Charger Housing.
Step 5: Unscrew the electronic circuit board (1 screw only).
Step 6: Unplug battery connector on the circuit board. Do not cut battery wires.
Step 7: Remove battery by tilting it up and dispose of according to local regulations.

Publicité

loading

Ce manuel est également adapté pour:

Iluma prime