Trust GM-3400 Mode D'emploi page 5

USER'S MANUAL
Product information
A: Race wheel
B: Feet pedals
C: USB connector
Installation PC
1 (1)Turn on the PC. (2) Connect USB to PC.
2 USB wheel ready to use.
3 Open Game Controllers in Windows Control Panel. Test all functions.
Settings for PC and Playstation2
Press Select+D-pad (right) to cycle through sensitivity settings:
Level 1: green LED
4
Level 2: yellow LED
Level 3: red LED
(Level 1 least sensitive and level 6 most sensitive)
Press Select+D-pad (up) for 1 second to switch on/off the vibration feedback:
5
All 3 LEDS will flash 3 seconds for confirmation
Feet pedals are hot swappable. Hand levers functions:
6 Pedals connected:
Pedals not connected: Hand levers "F" and "G" function as throttle and brake.
Programming buttons: (Δ, O, X,
Step1: Press Select for 3 seconds
Step2: Press button you want to change
Step3: Press button of the function you want to assign
7 (All 3 LEDS will flash for confirmation)
Step4: Press Select to Exit programming mode.
Pressing Mode button for 3 seconds will reset all programmed button to their default setting.
(Red LED will flash for confirmation)
Note
Force Vibration only works with PlayStation2 games supporting vibration.
Analogue and Digital function depends on Playstation2 games.
Use on PlayStation2
• Please follow PlayStation2 instruction manual.
• Buttons 1 – 4 / Δ, O, X,
this function.
All manuals and user guides at all-guides.com
Level 4: yellow and green LED
Level 5: yellow and red LED
Level 6: green and red LED
Hand levers "F" and "G" have same functions as Δ and O
, L1, R1, L2, R2, L3, R3)
, and hand levers are pressure sensitive, only with PlayStation2 games supporting
1
D: Playstation2 connector
E: Table clamp UK