Phoenix Contact TESTFOX CC Notice D'emploi page 17

All manuals and user guides at all-guides.com
- recognizable consequences of prolonged storage under inadmissible
conditions and
- recognizable consequences of extraordinary stress due to transport.
In such cases, immediately switch off the TESTFOX CC, disconnect it from the
measuring points and secure it against further use.
9.2 Cleaning
Clean the exterior of the device with a clean dry cloth (exception: special
cleaning wipers). Do not use any solvents and/ or abrasives to clean the device.
Strictly observe that the battery compartment and the battery contacts are not
contaminated by leaking battery electrolyte. If there are electrolyte contamination
or white deposits in the area of the battery or the battery housing, clean these
areas as well by means of a dry cloth.
9.3 Battery replacement
Before opening the TESTFOX CC, strictly observe that the

device is free of voltage! Electrical danger!
The TESTFOX CC is supplied by means of two integrated 1.5 V micro batteries.
Battery replacement (see figure 6) is required, if the battery symbol 1 appears
on the display 3.
Proceed as follows to replace the battery:
- Disconnect the safety measuring lines from the measuring circuit.
- Disconnect the safety measuring lines from the TESTFOX CC.
- Switch the sliding switch 7 to position „OFF".
- Put the TESTFOX CC face down and unscrew the screw of the battery
compartment cover.
- Remove the discharged batteries from the battery compartment.
- Place the batteries into the battery compartment at the provided place.
- Lock the battery compartment cover into place on the bottom part and
tighten the screws.
See figure 6:
Make your contribution for environmental protection! Do not
dispose of discharged batteries via the household waste.

Instead, return them to a collecting point for discharged
batteries or spezial waste. Please look for information in your
community's facilities.
9.4 Calibration
To maintain accuracy of the measuring results, the device must be recalibrated
in regular intervals by our factory service. We recommend recalibrating the
device once a year.
10. Technical data of the measuring accessories
4 mm safety measuring line ATL 2
- Standard: EN 61010-031,
- Maximum rated voltage to earth ( ) and measuring category:
1000 V CAT III, 600 V CAT IV,
- Maximum rated current: 10 A,
- Protection class II (  ), continuous double or reinforced insulation,
- Contamination class: 2,
- Length: 1.4 m, AWG 18,
- Ambient conditions:
Barometric height for measurements: max. 2000 m,
Temperature: 0 °C to + 50 °C, humidity 50 % to 80 %
- Use the measuring lines in perfect condition and according to these
operating instructions only, as otherwise the protection provided might be
impaired.
- Replace the measuring lines, if the insulation is damaged or if the conductor/
connector is interrupted.
- Do not touch the bare contact tips of the measuring lines. Only touch the
area intended for your hands!
- Insert the bent terminals into the testing or measuring device.
11. Environmental protection
At the end of product life, dispose of the unserviceable device via
appropriate collecting facilities provided in your community.
10/ 2008
Battery replacement
TESTFOX CC

13