Phoenix Contact TESTFOX CC Notice D'emploi page 13

All manuals and user guides at all-guides.com
2. Safety instructions
The instrument is built and tested in accordance with
DIN VDE 0411 Teil 1/ EN 61010-1
and has left the factory in perfectly safe technical condition.
To preserve this condition and to ensure safe operation of the device, the user
must observe the notes and warnings given in these instructions at all times.
The TESTFOX CC must be used in electrical circuits of over­
voltage category III with a conductor for a maximum of 600 V
to earth only.

Please observe that work on live parts and electrical compo­
nents of all kinds is dangerous! Even low voltages of 30 V AC
and 60 V DC may be dangerous to human life.
Before starting the current clamp multimeter, always check the

device as well as all cables for damages.
If it can be assumed that safe operation is no longer possible, switch the device
off immediately and secure it against unintended operation.
Safe operation can be assumed to be no longer possible, if
- the device or the measuring lines exhibit visible damages,
- the device no longer works,
- the device has been stored under unfavourable conditions for a longer
period of time,
- the device was exposed to extraordinary stress during transport.
In order to prevent danger
­ do not touch the bare measuring probe tips of the

measuring lines,
­ insert the measuring lines into the respectively designated
measuring sockets of the multimeter.
3. Scope of delivery
The scope of delivery of the TESTFOX CC comprises:
3.1 One TESTFOX CC,
3.2 One safety measuring cable, red (L = 1.4 m; probe tip Ø = 4 mm),
3.3 One safety measuring line, black (L = 1.4 m; probe tip Ø = 4 mm),
3.4 One compact protective pouch,
3.5 Two 1.5 V micro (AAA) batteries for initial assembly are integrated into
the device
3.6 One operating manual.
Parts subject to wear:
- The TESTFOX CC is supplied by means of two integrated 1.5 V micro
(AAA) batteries (IEC LR 03).
- The safety measuring cables ATL-2 mentioned above (tested accessories)
comply with CAT III 1000 V and are approved for a current of 10 A.
4. Device description
See figure 1:
The display and operating elements shown in figure 1 are designated as
follows:
1 Digital display, displaying measured value and range exceedance
2 Polarity indication,
3 Battery indication, appears in case of discharged battery,
4 HOLD key, storage of the displayed measured value,
5 MAX key, storage of the highest measured value,
6 Key (change­over), for selecting AC voltage/ DC voltage or resistance
measurement/ continuity test
7 Sliding switch, for selecting the measuring function,
8 Jack (positive
9 COM jack, common jack for voltage/ resistance measurements and
continuity test,
J Opening lever, for opening and closing the current clamp,
K Bulge for current clamp, protects against contact with conductor,
L Measuring clamp, for clamping on the single-wire live conductor,
This is what the automatic polarity indication for DC voltage refers to
1)
10/ 2008
Device front
), for V and Ω
1
TESTFOX CC

9