Inficon D-TEK Select 712-202-G Série Manuel D'utilisation page 11

Removing/Replacing the Power Stick
D-TEK Select uses a pre-assembled power stick.
Remove the battery compartment door on the back of D-TEK Select by pressing
on both release buttons on the grip and pulling the door straight out. The power
stick is connected to the PCB board via a miniature electrical connector.
Disengage the connector and slide the power stick out of D-TEK Select.
Slide the new power stick into D-TEK Select and push the miniature connector on
the power stick into the mating half on the PCB board. Do not bend the PCB
board's connector away from the board. Once the power stick is in place, close
the battery compartment by aligning the two tabs and sliding the door straight in
until it latches. Ensure the wire leads on the power stick are not pinched in the
door. Allow 10 hours to fully charge the new power stick.
NOTE: If D-TEK Select does not power up after the power stick is replaced,
check that the key connector on the power stick is mated properly to the
connector on the circuit board. Reverse the connection if necessary and
power up again. If the HI/LO indicators flash in a rapid, alternating manner
when the AC adapter is connected, the power stick is installed
backwards.
11