JaKSports Ski-Mojo Manuel Utilisateur page 16

FIRST FITTING
❸ Undo (open) the clamp holding
the lower Telescopic rod. Slide the
pivot of the mojo up until it is
alongside your knee and then close
(do-up) the clamp.
❹ Slide the top of the telescopic rod
into the hole in the bottom of the
Harness connector. If you want to
disconnect a leg from the harness,
just press the golden button on the
harness connector and pull-up the
harness.
❺ Do up the Velcro shin-strap as
tightly as is comfortably possible. Do
up the thigh strap.
❻ Stand up and open the clamp
holding the upper Telescopic rod.
Then adjust the length until the
harness connector is 5 to 7 cm below
the widest part of the waist. Close the
clamp
Tip: Once you've set the telescopic rods to length on the first leg you can simply set the
telescopic rod of the other leg to the same length before attaching it to your ski boot.
⑤
ENGAGE / DIS-ENGAGE
To switch on (engage) the mojos, push the switches
down - then straighten your legs (you may hear a click
as it engages).
To switch off (dis-engage) the mojos, flip the switches
up - then straighten your legs.
YOU CAN NOW ENJOY THE
EFFECT OF YOUR SKI-MOJO
Advice :
 Dis-engage the Ski-Mojo when not skiing, to walk, to drive or in a restaurant.
 If activation is difficult during the first days or if you cannot raise your leg enough, don't
force the system. Just engage the activation switch, stretch your leg as much as you can
and gently but firmly, pull up the upper part of your Ski-Mojo with your hand.
5 to 7 cm
SKI
16