JaKSports Ski-Mojo Manuel Utilisateur page 15

FIRST FITTING
③ INSTALLING THE HARNESS
We recommend to use your Ski-Mojo under your ski pants, except for the first day, in order
to facilitate handling.
With the elastic straps hanging below the main strap, step into the loops of the harness. Pull
the Harness up so that the main strap is UNDER your buttocks.
Check the position of the Harness connectors. The hole at the bottom of the connector should
be in line with the outside of your thigh. If the Harness connectors need to be moved, then
peel off the Velcro and re-position in the correct place (there are lines of red stitching every
5cm as a guide). You may need to ask someone to help you.
Correct adjustment of the harness is an important step. Do not skip it!
Check the position of the Harness connectors
④ FITTING YOUR MOJO LEGS
Your Ski-Mojo is equipped with a left leg
and a right leg ("L" and "R" indicated on the
neoprene). For each leg, please follow this
procedure:
❶ Open the clamp of each telescopic rod
(upper one and lower one) and slide them
out. Graduations will then appear.
preset to 4 if you are over 1m80 tall

preset to 2 if you are less than 1m80

tall
❷ Slide up the sleeve on the end of the
lower telescopic rod to expose the socket.
Place the socket on to the ball stud on the
boot and release the sleeve.
Step into
the loops
of the
harness
The main strap
should be
under you
buttocks
If needed, adjust their position by
repositioning the velcro
SKI
15