LiteHawk CLICK AUTO Guide D'utilisation page 7

Your LiteHawk Drone is equipped with a barometric sensor which allows for
Altitude hold capability. The Drone will maintain your desired height while
flying.
ALTITUDE HOLD: You will notice the left stick is spring
loaded. To gain or increase altitude (height) push the stick
up. To lower altitude (height) push down. Once you get to
a desired altitude release the stick and the drone will stay
at that height.
The left control stick (throttle) is now spring loaded and
rests in the center position. If you want to climb just push
up on the throttle stick and release when you reach your
desired height. To lower the drone's height just push
down on the throttle stick.
AUTO TAKE OFF: Press the Auto Take off button to
launch your drone. This will launch your drone to a
comfortable height (Exact height may differ).
AUTO LAND: Press the Auto land button and the drone
will land itself.
LiteHawk CLICK AUTO - First Flight
If you've never flown then the first thing you need to learn is throttle control. Slowly and
carefully ramp up the throttle until the model starts to lift off, then as soon as the model
leaves the ground, ease off the throttle gently and let it settle back down. If the hardware
is working correctly the model should remain fairly level, and shouldn't drift too far.
Repeat this process, lift off gently and then land again, until you have a good feel for how
much throttle is required to keep the model in the air. Try keeping it in the air a little
longer - don't worry about pitch or yaw and - all we care about right now is that the
model stays at a steady height. Don't go more than a meter off the ground. If the model
drifts too far, ease off the throttle and land it.
When heading out to fly your model, it's important to always use common sense.
Do not fly in the following places: Near crowds or high voltage, near any obstacles, wind
speeds over C (3mph), thunder, rain or snow or between high buildings.
- Ensure nothing prevents the smooth running of the moving parts.
- Do not dismantle or tamper with this R/C product or its transmitter. The manufacturer
and distributor will accept no responsibility, expressed or implied, for accidents or injuries
caused as a result of dis-assembly, modification and/or usage against the instructions for
this product.
- Ensure that all batteries are correctly installed and that the Li-Po battery is fully charged
and in good condition.
All manuals and user guides at all-guides.com
www.litehawk.ca
R