LiteHawk CLICK AUTO Guide D'utilisation page 6

Right Flip:
Hold the right stick to the
right once and your CLICK
AUTO will do a right flip.
Left Flip:
Hold the right stick to the left
once and your CLICK AUTO will do
a left flip.
How to charge the LiteHawk CLICK AUTO:
Your LiteHawk CLICK AUTO comes with a LiPo battery which is
inside the model. The rechargeable Li-Po battery provides the
power to propel your model at high speeds. You should expect
3-5 min run time. However you do need to make sure to
properly maintain your Li-Po Battery.
- Li-Po batteries don't like to be run down too low. If the
voltage is dropped dramatically they will be damaged and will
not recharge! Once the model starts to slow, drive your model
to a safe place, walk over and turn it off.
- It is recommend to charge the battery after your run and to
always store the battery with a charge. Never discharge or
dead short a Li-Po battery!
Always have your model turned off when not in use. Make
sure the switch is turned OFF.
1/ Plug the USB into your computer, TV, or USB charger. The LED light on the USB will turn
RED.
2/ Plug the other end of the cable into your Litehawk CLICK AUTO battery port located at
the side of the model. Do not force the plug, it only goes in one way. The model must have
the power switch in the OFF position. The LED light on the USB will turn OFF.
3/ Charge time can take up to 30 minute (shorter if charging for the first time). Once
charged the LED light on the USB will turn back to solid RED.
Tip: If storing for more than 24 hours it is best to store with a fully charged battery.
Failure to do so can damage the battery pack and shorten its useful life.
During charging:
- It is normal for the battery to get warm during the charging process. Do not charge
the battery on a surface that is flammable or can be damaged by heat.
- Do not leave the battery and charger unattended while charging.
- After charging, unplug charger from model.
- Do not store the model plugged into the charger.
How To Sync
1/ Make sure the model is turned Off and locate a flat level surface.
2/ Turn the CLICK AUTO On. Place the CLICK AUTO on the flate surface, you must do this
within five seconds of turning the power switch ON.
3/ Turn on the power for the controller.
4/ Move the left control stick (this is also the throttle stick) all the way up, then all the
way down. You will hear a beep. The model is now bound.
The CLICK AUTO MUST be on a flat surface in order to digitally self level itself, otherwise
the model will not sync to the controller.
All manuals and user guides at all-guides.com
www.litehawk.ca
On / Off
R