Caso Germany GF100 Mode D'emploi page 38

12.3 Setup location requirements:
12.4 Unpacking
caso GF100
All manuals and user guides at all-guides.com
In order to ensure the safe and trouble-free operation of the
device, the setup location must fulfil the following prerequisites:
The device must be set up on a firm, flat, horizontal and heat
resistant surface with sufficient load-bearing capacity for the
device.
Choose the setup location in such a way that children cannot
reach the device.
The device is not intended to be installed in a wall or a built-in
cupboard.
Do not set up the device in a hot, wet or extremely damp
environment or near flammable material.
The device requires an adequate flow of air in order to operate
correctly. Leave a clearance of 15 cm on all sides.
Do not cover up any openings on the device and do not block
these off.
Do not remove the device's adjustable feet.
The electrical socket must be easily accessible so that the
power lead can be disconnected easily, in the case of an
emergency.
The installation and assembly of this device in non-stationary
setup locations (e.g. on ships) must be carried out by specialist
companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
To unpack the device, proceed as follows:
• Place the box containing the unit on a countertop or table.
• Remove the device from the box and remove the outer
packaging.
• Then remove the foil, which protects the cover.
• In the fryer are polystyrene particles. Remove these and then
the basket.
• Remove the clear plastic and cardboard, which is located in and
around the basket.
Commissioning
38