Daikin Split FTX20K2V1B Mode D'emploi page 17

Indoor Unit Installation
3) Shape the refrigerant pipes along the pipe
path marking on the mounting plate.
4) Pass the drain hose and refrigerant pipes
through the wall hole, then set the indoor
unit on mounting plate hooks, using the
markings at the top of the indoor unit as
a guide.
5) Pull in the inter-unit wire.
6) Connect the inter-unit pipes.
7) Wrap the refrigerant pipes and drain hose together with insulation tape as
shown in the figure on the right (in case of setting the drain hose through
the back of the indoor unit).
8) While exercising care so that the inter-unit wire does not catch indoor unit,
press the bottom edge of indoor unit with both hands until it is firmly caught
by the mounting plate hooks. Secure indoor unit to the mounting plate with
indoor unit fixing screws (M4 × 12L).
3-3. Wall embedded piping
Follow the instructions given under left-side, left-back, or left-bottom piping.
1) Insert the drain hose to this depth so it won't be pulled out of the drain pipe.
English
All manuals and user guides at all-guides.com
Drain
hose
Caulk this hole
with putty or
caulking material.
Mounting plate
Wrap insulating tape around the
bent portion of refrigerant pipes.
Bind with adhesive
Overlap at least half the width of
vinyl tape.
the tape with each turn.
Inter-unit wire
Drain hose
Bottom frame
Indoor unit fixing screw
(M4 × 12L) (2 locations)
Insert drain hose
to this depth so
it won't be pulled
out of drain pipe.
50mm
or more
Outer wall
Mounting
plate
Refrigerant
pipes
Inner wall
Drain hose
Vinyl chloride
drain pipe
(VP-30)
10