Daikin Split FTX20K2V1B Mode D'emploi page 14

Indoor Unit Installation
WARNING
• Only use accessories, optional equipment and spare parts made or approved by DAIKIN.
• Installation shall be done by an installer, the choice of materials and installation shall comply with the applicable legislation.
In Europe, the EN378 is the applicable standard that shall be used.
1.
Installing the mounting plate
• The mounting plate should be installed on a wall which can support the weight of the indoor unit.
1) Temporarily secure the mounting plate to the wall, make sure that the panel is completely level, and mark the boring points
on the wall.
2) Secure the mounting plate to the wall with screws.
Recommended mounting plate retention spots and dimensions
Class 20/25/35:
Place the pipe port cover The removed pipe
in this pocket.
port cover can be
kept in the mounting
plate pocket.
Class 50/60/71:
122
56.5
7
All manuals and user guides at all-guides.com
Recommended mounting plate
retention spots (7 spots in all)
117
213
48 170
337
Removed pipe
port cover
Recommended mounting
plate retention spots
(5 spots in all)
Liquid pipe end
PIPING HOLE
CENTER:170mm
TO THE LEFT
Gas pipe end
170
475
Place a leveler
on these tabs.
237
A
Gas pipe end
170
50
337
Liquid pipe end
770
A Mounting
plate
Place a leveler
on these tabs.
60
404
990
Through-the-wall
hole Ø65
Drain hose position
116.5
48
Use a tape measure
as shown.
Position the end of
the tape measure at
Through-the-wall
hole Ø65
Drain hose
position
121.5
PIPING HOLE
CENTER:170mm
TO THE LEFT
A
170 56.5
.
English