Publicité
Les langues disponibles
Les langues disponibles
OPERATION
1.
Plug the heater into a suitable power outlet, observing all the instruction regarding
positioning and switch on.
To use the fan only function:
2.
Turn the control dial to " ". The fan will blow out air at room temperature.
3.
If the fan does not operate, the ambient room temperature is cooler than the built-
in thermostat "OFF" level. Turn the thermostat dial gradually clockwise and the
fan will start blowing.
4.
As soon as the fan starts, the light in the front of the machine will illuminate.
To use the machine for heating:
5.
Turn the control dial to "I" for low heat and "II" for full heat.
6.
Set the level of heat by turning the thermostat dial gradually clockwise for the
lowest heat and fully clockwise for maximum.
7.
The thermostat will turn the machine off when the selected room heating is
achieved, and when the temperature drops it will turn on again automatically.
8.
For maximum heat output use "II" with the thermostat turned fully clockwise.
OVERHEATING
1.
Once the room reaches the required temperature, the heating element will stop
working but the fan continues working. Once the temperature decreases, the
heating element will be working again. The fan heater now starts and stops
automatically and thus keeps the room temperature constant.
2.
The thermostat will turn the machine off if it overheats.
3.
Overheating can be caused by obstruction to the air intakes on the bottom of the
machine or the metal grill on the top. If this occurs please disconnect the machine
and allow it to cool for 30 minutes. Remove any obstruction and turn the machine
back on.
TIP-OVER-PROTECTION
The appliance is fitted with a tip-over switch. When you use the appliance in an upright
position on a flat and stable surface, the tip-over switch will be on. In the event that the
heater is knocked over, the heater will stop functioning automatically.
All manuals and user guides at all-guides.com
40 | 41
GB
Publicité
