Télécharger Imprimer la page

Philips SoniCare HealthyWhite 700 Serie Manuel D'utilisation page 7

Masquer les pouces Voir aussi pour SoniCare HealthyWhite 700 Serie:

Publicité

Les langues disponibles

Les langues disponibles

1
1
2
2
4
4
3
3
4235.020.2528.2.indd 7
4235.020.2528.2.indd 7
All manuals and user guides at all-guides.com
-
Flashing green: 10-49%
-
Flashing yellow: less than 10%
Standard charge indicator (select models):
-
Solid green: 50-100%
-
Flashing green: less than 50%
Note: When the battery of your Sonicare is low, you hear 3 beeps after the
completion of the brushing cycle and the battery charge indicator fl ashes for
30 seconds.
Note: To keep the battery fully charged, you may keep your Sonicare on the
charger when not in use. It takes 24 hours to fully charge the battery.
Using your Sonicare
Brushing instructions
1
Wet the bristles and apply a small amount of toothpaste.
2
Place the toothbrush bristles against the teeth at a slight angle
towards the gumline.
3
Press the power on/off button to turn on the Sonicare.
4
Apply light pressure to maximize Sonicare's effectiveness and let the
Sonicare toothbrush do the brushing for you.
5
Gently move the brush head slowly across the teeth in a small back
and forth motion so the longer bristles reach between your teeth.
Continue this motion throughout your brushing cycle.
Note: To make sure you brush evenly throughout the mouth, divide your mouth
into 4 sections using the Quadpacer feature (see chapter 'Features').
6
Begin brushing in section 1 (outside top teeth) and brush for
30 seconds before moving to section 2 (inside top teeth). Continue
brushing in section 3 (outside bottom teeth) and brush for
30 seconds before moving to section 4 (inside bottom teeth).
7
After you have completed the brushing cycle, you can
spend additional time brushing the chewing surfaces of your teeth
and areas where staining occurs. You may also brush your tongue,
with the toothbrush turned on or off, as you prefer.
Your Sonicare is safe to use on:
-
Braces (brush heads wear out sooner when used on braces)
-
Dental restorations (fi llings, crowns, veneers)
Note: The toothbrush may be turned off at any time by pressing and holding
the power on/off button for 2 seconds.
Clean and White mode brushing instructions
The Clean and White mode combines 2 minutes of Clean mode for a
whole mouth clean, with an additional 30 seconds of White mode to focus
on the visible front teeth.
1
Brush the fi rst 2 minutes as instructed in steps 1-6 above.
ENGLISH
7
10-07-2008 10:56:34
10-07-2008 10:56:34

Publicité

loading